Teka EM 30 2P Manuel d'utilisateur télécharger pdf (Page 12)

GB

12

Special requirements before

starting for the first time

Before connecting the hob to the electric

mains, check that the voltage and fre-

quency of the mains matches what is

shown on the hob’s rating plate, which is

located lower down, and on the guarantee

or, where appropriate, the technical datas-

heet supplied, which should be kept toge-

ther with this manual.

Remember that you may have to remove

the protective plastic cover that is stuck to

the hob.

Igniting the burners

* Make sure that the knobs are in their

correct position.

* Turn on the gas at the mains or turn the

gas cylinder’s tap.

* Put a flame or spark to the burner if you

do not have automatic ignition.

Press the control knob and at the same

time turn it anti-clockwise to the maximum

position (the big flame, “C” in figure 3). The

burner will now come on at full power;

then, if you wish, you can turn the knob to

the minimum position (the small flame,

“D”).

With hob models that have automatic igni-

tion and the safety feature, proceed as

follows:

1 Press down the burner control.

2 Keeping the burner control pressed

down, turn it all the way till the gas igni-

tes, and keep it pressed down for at

least 2 seconds so that the safety ther-

mocouple can take effect.

3 Set the control to the position required.

In order for the automatic ignition system

to work properly, it is vital that the ignition

(the ceramic and the electrode) is cleaned

regularly and carefully - this will avoid igni-

tion problems. Check, too, that the groo-

ves in the burners have not become obs-

tructed.

On the control panel, areas are marked (A)

that show the control for each burner.

If a gas smell is noted, the gas intake to

the hob should be shut off and the room

ventilated. The gas installation and the hob

should also be checked by a specialised

technician.

Use flat-bottomed pans and check that

they sit squarely on the grid, so that when

food boils the pan does not slip (do not use

pans with a concave or convex base).

Use and Maintenance

‘Burner in operation’ indicator

Knob position when not in use

Maximum gas position

Minimum gas position

fig. 3

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Commentaires sur ces manuels

Pas de commentaire