Teka EM 30 2P Manuel d'utilisateur télécharger pdf (Page 7)

GB

7

Important

INSTALLATION AND SETUP SHOULD

BE CARRIED OUT BY AN AUTHORISED

TECHNICIAN IN LINE WITH CURRENT

INSTALLATION STANDARDS.

Positioning the hobs

A gap with the dimensions shown in figure

1 will be cut into the worktop or stove.

The system for fixing the hob is intended

for use with kitchen units with a thickness

of 20, 30 or 40 mm.

In free-standing models, a shelf should be

placed inside the unit. The minimum dis-

tance between the lower part of the hob

and the upper part of the shelf should be

20 mm.

The hobs described in this manual can

only be installed with TEKA ovens.

The minimum distance between the surfa-

ce supporting the cooking pans and the

lower part of the kitchen unit or the hood

located above the hob should be 650 mm.

If the hood’s installation instructions

recommend that the gap is greater than

this, you should follow this advice.

The unit where the hob and oven will be

located will be suitably fixed.

When hobs are handled before

being installed, care should be taken in

case there is any protruding part or

sharp edge which could cause injury.

When installing units or applian-

ces above the hob, the hob should be

protected by a board so that the glass

cannot be damaged by accidental

blows or heavy weights.

If the glass ceramic breaks or

cracks, the hob should immediately be

disconnected from the electric current

in order to avoid the risk of electric

shock.

The glues used in manufactu-

ring the kitchen unit and in the adhesi-

ve on the decorative laminate of the

worktop surface should be made to

tolerate temperatures of up to 100ºC.

Installation

fig. 1

Minimum distances

to walls

Minimum ventilation

distances

Installation

space

40 mm minimum

40 mm minimum

OVEN

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Commentaires sur ces manuels

Pas de commentaire