Teka EM 30 2P Manuel d'utilisateur télécharger pdf (Page 9)

GB

9

located lower down, and on the guarantee

certificate or, where appropriate, the tech-

nical datasheet supplied, which should be

kept together with this manual.

The connection is made via an omnipolar

switch or plug where accessible, which is

suitable for the intensity to be tolerated

and which has a minimum gap of 3 mm

between its contacts, which will ensure

disconnection in case of emergency or

when cleaning the hob.

The connection should include correct ear-

thing, in compliance with current norms.

If the flexible supply cable fitted to these

appliances ever needs to be changed, it

should be replaced by TEKA’s official service.

The input cable should not be in contact

either with the body of the hob or with the

body of the oven, if the oven is installed in

the same unit.

Gas conversion

Important!

Any alteration that is to be made to the

appliance to convert it to a different

type of gas should only be carried out

by an authorised person and should

comply with current standards.

Information for Technical

Assistance: whenever the type of gas or

the appliance’s pressure is changed, the

new regulation plate should be placed on

top of the old one so that the new features

can be seen after the change.

The tasks involved in conversion are:

* Replace the injectors.

* Adjust the taps’ minimums.

The injectors required for each gas type

are shown in table 1.

To replace the injectors, follow these ins-

tructions:

1 Remove the grids and upper parts of the

burner so that the injector can be seen.

2 Using a number 7 pipe spanner, remove

the injectors and replace them with the

new ones. Take good care to tighten the

injector properly and so avoid gas esca-

ping.

3 Replace the grid and burners that were

previously removed.

When the injectors have been changed,

this is how to adjust the minimums:

1 Turn the burners on to their minimum.

2 Remove the cooker’s controls in order to

be able to access the gas taps.

3 Use a slim, grooved screwdriver to turn

the screw located to the left or in the

centre of the gas tap’s shaft (the flame

increases when you turn to the left and

decreases when you turn to the right).

4 When properly adjusted, check that the

flame does not go out when you turn the

knob quickly from maximum to mini-

mum.

TEKA INDUSTRIAL, S.A. assumes no

responsibility for any hob malfunction if the

gas conversion or the adjustment of the

burners’ minimums has not been carried

out by TEKA’s official personnel.

Ø injector expressed in 1/100 mm.

Burner

Rapid

Auxiliary

Table 1

Family

Third

Group 3+

85

50

Group H

116 Y

72 X

Group E+

116 Y

72 X

Second

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Commentaires sur ces manuels

Pas de commentaire