Teka EM 30 2P Manuel d'utilisateur télécharger pdf (Page 13)

GB

13

Only pans with a minimum diameter of 140

mm should be used on each burner. If you

wish to use a pan with a diameter of 120

mm or smaller, it should be placed on the

auxiliary burner or on the grid accessory.

Please note:

When the burners are in opera-

tion or have recently been in operation,

the hob will be hot in places and this

can lead to burns. Children should be

kept well away.

For safety reasons, we advise

that the instructions provided by the

gas supply company are followed and

that the supply tap is turned off when

the hob is not in use.

The device shall not be operated

for more than 15 seconds. If after 15

seconds the burner has not lit, stop the

device and open the compartment door

and/or wait at least 1 minute before

attemting a futher ignition of the burner.

In the event of the burner flames

being accidentally extinguished, turn

off the burner control and do not

attempt to re-ignite the burner for at

least one minute.

Anti-accidental turn system

on gas controls

On models without the safety

system (without the gas cut-off device),

the gas taps are equipped with a mechani-

cal system that prevents the controls from

being freely turned from the off position to

the on position (and, therefore, prevents

any accidental escape of gas from the bur-

ners) if the control has not previously

been pressed down.

If at any time while using the hob

you notice that a control can be turned

from the off position without it needing

to be pressed down beforehand (for

example: because of dirt which may

have got into and accumulated in the

gas taps) you should, for your own

safety, quickly notify the technical servi-

ce so that the problem can be rectified.

Safety system components

(fig. 4)

On hobs with the safety feature (those

models which have the letters AL), the gas

cut-off device is made up of these ele-

ments:

* The safety tap

* The safety thermocouple, next to the

burner

* The thermocouple-tap connection

The thermocouple sends an electric signal

to the tap which identifies whether the bur-

ner has a flame. During ignition, the tap

should be held down for around two

seconds, until the thermocouple has hea-

ted up and can send a satisfactory electric

fig. 4

Safety thermocouple

Thermocouple-tap connection

Spark generation connection

Ignition spark plug

Safety tap

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Commentaires sur ces manuels

Pas de commentaire